Error: DRVSPACE Error: Drive A:...(due to misaligned heads or problem floppy).
Error:
DRVSPACE Error: Drive A: (F:\DRVSPACE.000). An error occurred while reading or writing the bitfat on this drive. To fix the problem, run ScanDisk and perform a thorough test of drive A and its host drive F.
Cause:
This error message may occur because of a misalignment of the heads on the floppy drive or because of a problem with the floppy disk,
Solution:
This error message may be safely ignored. If this error message persists reformat the floppy disk or have the diskette drive checked by the drive's manufacturer.
Do one of the following:
1) Reformat the floppy disk:
a) Double-click the 'My Computer' icon. (The 'My Computer' window appears.)
My Computer window
b) Highlight the appropriate floppy drive icon.
c) Do one of the following to display the 'Format floppy disk' dialog box:
1] Select the 'File' menu and select 'Format...'. (The 'Format' dialog box appears.)
2] Display the drive's pop-up menu:
a] Right-click on the appropriate on the 'floppy drive' icon.
b] Select 'Format...' from the pop-up menu. (The 'Format' dialog box appears.)
d) Select the correct diskette capacity from the 'Capacity' drop-down list box.
e) Select one of the radio buttons in the 'Format type' group:
1] Select 'Quick (erase)' to only erase the files on the disk.
2] Select 'Full' to erase all the files on the disk and scan the disk for bad sectors after it is formatted.
3] Select 'Copy system files only' to copy system files to the disk without erasing files that are already on the disk.
f) (Optional) Type a name for the formatted disk in the 'Label' box.
NOTE: To specify that you do not want to name the formatted disk, select the 'No label' check box in the 'Other options' group.
g) (Optional) Select the 'Display summary when finished' check box to display information about the disk after it is formatted.
NOTE: To prevent a summary from being display, clear the 'Display summary when finished' check box.
h) Select the 'Copy system files' check box to copy system files to the disk after formatting, so the disk can be used to startup the computer.
NOTE: To prevent system files from being copied to the diskette after the disk is formatted, clear the 'Copy system files' check box.
i) Click 'Start'.
2) Have the diskette drive checked by the drive's manufacturer.
